Show Ip Igmp Interface - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
Up Time
Expiry Time
Version1 Host
Timer
Version2 Host
Timer
Group
Compatibility
Mode

15.5.12 show ip igmp interface

This command displays the IGMP information for the interface.
Format
Modes
Interface
IGMP Admin
Mode
Interface Mode
IGMP Version
Query Interval
15-34
This displays the time elapsed since the entry was created for
the specified multicast group address on this interface.
This displays the amount of time remaining to remove this
entry before it is aged out.
This displays the time remaining until the local router
assumes that there are no longer any IGMP version 1 multi-
cast members on the IP subnet attached to this interface. This
could be an integer value or "-----" if there is no Version 1
host present.
This displays the time remaining until the local router
assumes that there are no longer any IGMP version 2 multi-
cast members on the IP subnet attached to this interface. This
could be an integer value or "-----" if there is no Version 2
host present.
The group compatibility mode (v1, v2 or v3) for this group
on the specified interface.
show ip igmp interface <slot/port>
Privileged EXEC
User EXEC
Valid slot and port number separated by forward slashes.
The administrative status of IGMP.
This field indicates whether IGMP is enabled or disabled on
the interface.
The version of IGMP running on the interface. This value can
be configured to create a router capable of running either
IGMP version 1 or 2.
The frequency at which IGMP Host-Query packets are trans-
mitted on this interface.
v1.0, December 2005
IP Multicast Commands