Distance Rip; Distribute-List Out - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

14.7.7 distance rip

This command sets the route preference value of RIP in the router. Lower route preference
values are preferred when determining the best route.
Default
Format
Mode
14.7.7.1 no distance rip
This command sets the default route preference value of RIP in the router.
Format
Mode

14.7.8 distribute-list out

This command is used to specify the access list to filter routes received from the source
protocol.
Default
Format
Mode
14.7.8.1 no distribute-list out
This command is used to specify the access list to filter routes received from the source
protocol.
Format
Mode
14.7.8.2 no default-information originate
This command is used to control the advertisement of default routes.
Format
Mode
14-60
15
distance rip <1-255>
Router RIP Config
no distance rip
Router RIP Config
0
distribute-list <1-199> out {ospf | bgp | static |
connected}
Router RIP Config
no distribute-list <1-199> out {ospf | bgp |
static | connected}
Router RIP Config
no default-information originate
Router RIP Config
v1.0, December 2005
Routing Commands