Show Classofservice Trust; Show Interfaces Cos-Queue - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

13.1.11 show classofservice trust

This command displays the current trust mode setting for a specific interface. The slot/port
parameter is optional and is only valid on platforms that support independent per-port
class of service mappings. If specified, the port trust mode of the interface is displayed. If
omitted, the most recent global configuration settings are displayed.
Format
Mode
Non-IP Traffic
Class
Untrusted Traffic
Class

13.1.12 show interfaces cos-queue

This command displays the class-of-service queue configuration for the specified
interface. The slot/port parameter is optional and is only valid on platforms that support
independent per-port class of service mappings. If specified, the class-of-service queue
configuration of the interface is displayed. If omitted, the most recent global configuration
settings are displayed.
Format
Mode
Queue Id
Minimum
Bandwidth
Scheduler Type
Quality of Service (QoS) Commands
show classofservice trust [slot/port]
Privileged EXEC
The traffic class used for non-IP traffic. This is only dis-
played when the COS trust mode is set to trust ip-precedence.
The traffic class used for all untrusted traffic. This is only dis-
played when the COS trust mode is set to 'untrusted'.
show interfaces cos-queue [slot/port]
Privileged EXEC
An interface supports n queues numbered 0 to (n-1). The spe-
cific n value is platform dependent.
The minimum transmission bandwidth guarantee for the
queue, expressed as a percentage. A value of 0 means band-
width is not guaranteed and the queue operates using best-
effort. This is a configured value.
Indicates whether this queue is scheduled for transmission
using a strict priority or a weighted scheme. This is a config-
ured value.
v1.0, December 2005
13-7