Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
14.6.37.1 no redistribute
This command configures OSPF protocol to prohibit redistribution of routes from the
specified source protocol/routers.
Format
Mode
14.6.38 maximum-paths
This command sets the number of paths that OSPF can report for a given destination
where
maxpaths
Default
Format
Mode
14.6.38.1 no maximum-paths
This command resets the number of paths that OSPF can report for a given destination
back to its default value.
Format
Mode
14.6.39 trapflags
This command enables OSPF traps.
Default
Format
Mode
14.6.39.1 no trapflags
This command disables OSPF traps.
Format
Mode
Routing Commands
no redistribute {rip | bgp | static | connected}
[metric] [metric-type] [tag] [subnets]
Router OSPF Config
is platform dependent.
4
maximum-paths <maxpaths>
Router OSPF Config
no maximum-paths
Router OSPF Config
enabled
trapflags
Router OSPF Config
no trapflags
Router OSPF Config
v1.0, December 2005
14-45