NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual page 237

This section describes the routing commands available in the 7300 Series Managed Switch
CLI.
This section contains the following topics:
• Section 14.1 "Address Resolution Protocol (ARP) Commands" on page 14-1
• Section 14.2 "IP Routing Commands" on page 14-8
• Section 14.3 "Router Discovery Protocol Commands" on page 14-19
• Section 14.4 "Virtual LAN Routing Commands" on page 14-22
• Section 14.5 "Virtual Router Redundancy Protocol (VRRP) Commands" on
page 14-23
• Section 14.6 "Open Shortest Path First (OSPF) Commands" on page 14-30
• Section 14.7 "Routing Information Protocol (RIP) Commands" on page 14-58
• Section 14.8 "Border Gateway Protocol (BGP) Commands" on page 14-66
The commands in this section are in one of two functional groups:
• Show commands are used to display switch settings, statistics and other information.
• Configuration Commands are used to configure features and options of the switch. For
every configuration command there is a show command that will display the
configuration setting.
14.1 Address Resolution Protocol (ARP) Commands
This section describes the commands you use to configure ARP and to view ARP
information on the switch. ARP associates IP addresses with MAC addresses and stores
the information as ARP entries in the ARP cache.
Routing Commands
Routing Commands
v1.0, December 2005
Chapter 14
14-1