Show Ip Mcast Mroute Static; Show Mrinfo - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
Outgoing
Interface List

15.1.16 show ip mcast mroute static

This command displays all the static routes configured in the static mcast table if is
specified or displays the static route associated with the particular <
Format
Modes
Source Address
Source Mask
RPF Address
Metric
Interface

15.1.17 show mrinfo

This command is used to display the neighbor information of a multicast-capable router
from the results buffer pool of the router subsequent to the execution/completion of a
mrinfo [ipaddr]
The results subsequent to the completion of the latest
buffer pool after a maximum duration of two minutes after the completion of the
command. A subsequent issue
mrinfo
with fresh results.
Default
Format
Mode
Router Interface
Neighbor
Metric
TTL
15-10
The list of outgoing interfaces on which this packet is for-
warded.
show ip mcast mroute static [<sourceipaddr>]
Privileged EXEC
User EXEC
The IP address of the multicast packet source.
The mask applied to the IP address of the multicast packet
source.
The IP address to be used as RPF for the given source and
mask.
The metric value corresponding to the source address.
Valid slot and port number separated by forward slashes.
command.
mrinfo
none
show mrinfo
Privileged EXEC
The IP address of this neighbor
The neighbor associated with the router interface
The metric value associated with this neighbor
The TTL threshold associated with this neighbor
v1.0, December 2005
sourceipaddr>
will be available in the
mrinfo
overwrites the contents of the buffer pool
IP Multicast Commands
.
show