Show Ip Pimsm Staticrp; Show Ip Pimsm - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

15.4.12 show ip pimsm staticrp

This command displays the static RP information for the PIM-SM router.
Format
Modes
RP IP Address
Group Address
Group Mask

15.4.13 show ip pimsm

This command displays the system-wide information for PIM-SM.
Format
Modes
PIM-SM Admin
Mode
Join/Prune
Interval (secs)
Data Threshold
Rate (K bits/sec)
Register
Threshold Rate (K
bits/sec)
Interface
Interface Mode
Protocol State
IP Multicast Commands
show ip pimsm staticrp
Privileged EXEC
User EXEC
The IP address of the RP.
The group address supported by the RP.
The group mask for the group address.
show ip pimsm
Privileged EXEC
User EXEC
This field indicates whether PIM-SM is enabled or disabled.
The interval at which periodic PIM-SM Join/Prune messages
are to be sent.
The data threshold rate for the PIM-SM router.
The threshold rate for the RP router to switch to the shortest
path.
Valid slot and port number separated by forward slashes.
This field indicates whether PIM-SM is enabled or disabled
on the interface.
The current state of the PIM-SM protocol on the interface.
Possible values are Operational or Non-Operational.
v1.0, December 2005
15-25