Service-Policy - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

13.5.1 service-policy

This command attaches a policy to an interface in the inbound direction. The
<policyname>
causes a service to create a reference to the policy.
Note: This command effectively enables DiffServ on an interface in the inbound
Note: This command fails if any attributes within the policy definition exceed the
Format
Modes
Note: You can only attach a single policy to a particular interface at any time.
13.5.1.1 no service-policy
This command detaches a policy from an interface in the inbound direction. The
<policyname>
Note: This command causes a service to remove its reference to the policy. This
Format
Modes
Quality of Service (QoS) Commands
parameter is the name of an existing DiffServ policy. This command
direction. There is no separate interface administrative 'mode' command
for DiffServ.
capabilities of the interface. Once a policy is successfully attached to an
interface, any attempt to change the policy definition, that would result in a
violation of the interface capabilities, causes the policy change attempt to
fail.
service-policy in <policymapname>
Global Config
Interface Config
parameter is the name of an existing DiffServ policy.
command effectively disables DiffServ on an interface in the inbound
direction. There is no separate interface administrative 'mode' command
for DiffServ.
no service-policy in <policymapname>
Global Config
Interface Config
v1.0, December 2005
13-21