Bgp Policy Action Addip Modify; Bgp Policy Action Remove - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
14.8.26.1 no bgp policy action addip
This command configures an 'delete' action on the policy identified with the specified
index. This command is used with matchtypes that use an IP Address as a modifier. The
possible values for the <
Format
Mode

14.8.27 bgp policy action addip modify

This command configures an 'modify' action on the policy identified with the specified
index. This command is used with matchtypes that use an IP Address as a modifier. The
possible values for the <
The < > and
ipaddr
only used if the <
Format
Mode

14.8.28 bgp policy action remove

This command removes an action identified by the <
identified with the specified index. The possible values for the <
origin, localpreference, multiexitdisc, community, confederationid,
clusternumber, nexthop, lenaspath, peer, atomicaggregate, aggregatoras,
and
aggregatorid.
If the matchtype is community, the integer value a 32-bit number. The first 16 bits
represent the AS number and the second 16 bits represent any arbitrary number. The
combination of the two 16-bit fields comprise the 32-bit community number. For example,
a system with AS number 1 and using arbitrary number 256 might specify community as
65792 which is equivalent to 0x00010100.
Format
Mode
14-78
are
matchtype>
no bgp policy action addip <index> <matchtype>
[ipaddr]
Router BGP Config
are
matchtype>
parameters are IP Addresses. The [
[ipaddr]
is
matchtype> clusternumber
bgp policy action addip modify <index> <matchtype>
<ipaddr> [ipaddr]
Router BGP Config
bgp policy action remove <index> <matchtype>
Router BGP Config
v1.0, December 2005
,
clusternumber nexthop
,
clusternumber nexthop
.
matchtype>
, and
aggregatorid
, and
aggregatorid
parameter is
ipaddr]
from the policy
are
matchtype> aspath,
Routing Commands
.
.