K&R GT600-4T132G User Manual page 82

4. Operating Panel (Keypad & Display)
4.2.3 Function Parameter Operations
■
4
- 80 -
Viewing Function Parameters
The drive provides three display modes for viewing parameters, described in Table 4-1.
Table 4-1 Function parameter display modes
Function Code Display Mode
Base mode
User-defined quick-view
mode
User-modified quick-view
mode
Press to cycle through three function parameter display modes. In each mode, the
QUICK
method you use to view and modify parameter value is the same as shown in
Figure 4-5 Switching between three function parameter display modes
Base mode
(all function parameters)
Default screen
QUICK
No key operation
within 2s
The value you set for function parameter FP-03 determines whether the operating panel
displays quick-view user-defined and quick-view user-modified function groups. The base
mode is always displayed.
Table 4-2 Setting FP-03 to select quick-view display modes
Value of FP-03
00
01
10
11 (default)
Parameter Name Setting Range
Show all function parameters in
sequence
The user can define up to 30 function
parameters to include into function
group FE.
The function parameters that have
been modified by a user are shown
here.
User-defined mode
(restricted in group FE)
QUICK
When
FP-03 = x1
Enter
Enter
...
...
... ...
User-modified Group
Not displayed
Not displayed
Displayed
Displayed
User-modified mode
(Modified parameters)
QUICK QUICK
When
FP-03 = 1x
Enter
...
...
User-defined Group
Not displayed
Displayed
Not displayed
Displayed
.