K&R GT600-4T132G User Manual page 122

6. Description of Parameters
6
- 120 -
Function Code Parameter Name
FC-41 Acceleration/deceleration time of
simple PLC reference 11
FC-42 Running time of simple PLC
reference 12
FC-43 Acceleration/deceleration time of
simple PLC reference 12
FC-44 Running time of simple PLC
reference 13
FC-45 Acceleration/deceleration time of
simple PLC reference 13
FC-46 Running time of simple PLC
reference 14
FC-47 Acceleration/deceleration time of
simple PLC reference 14
FC-48
Running time of simple PLC
reference 15
FC-49 Acceleration/deceleration time of
simple PLC reference 15
FC-16 determines the simple PLC running mode.
Function Code Parameter Name
FC-16
Simple PLC
running mode
●
FC-16 = 0: Stop after running one cycle
The AC drive stops after running one cycle, and will not start until it receives a new
RUN command.
●
FC-16 = 1: Keep final values after running one cycle
The AC drive keeps final running frequency and direction after running one cycle.
●
FC-16 = 2: Repeat after running one cycle
The AC drive automatically starts another cycle after running one cycle, and will not
stop until receiving stop command.
FC-17 determines whether the running data is retentive at power down or at stop.
If retentive, the running data is memorized at power down or at stop and the AC drive will
continue to run from the memorized data at next power-on.
If not retentive, the AC drive runs from the first simple PLC reference at next power-on.
Function Code Parameter Name
FC-17 Simple PLC retentive
selection
Setting Range
0 to 3
0.0s (h) to 6553.5s (h)
0 to 3
0.0s (h) to 6553.5s (h)
0 to 3
0.0s (h) to 6553.5s (h)
0 to 3
0.0s (h) to 6553.5s (h)
0 to 3
Setting Range
0: Stop after running one cycle
1: Keep final values after running one cycle
2: Repeat after running one cycle
Setting Range
0: Not retentive
1: Retentive
Unit position: Retentive at power down
Tens position: Retentive at stop
Default
0
0.0s (h)
0
0.0s (h)
0
0.0s (h)
0
0.0s (h)
0
Default
0
Default
00
- 119 -