●
Mounting hole diameter d
●
Overall dimensions of the housing H and W
●
Mark the backplate to identify the centers of the four mounting holes.
●
Mark an outline for the cut-out by using the dimensions H and W. Ensure the cut-out
is centred with respect to the mounting holes.
●
Carefully drill the four mounting holes.
●
Carefully cut a rectangular cut-out hole in the supporting surface according to the
markings you made in step 6.
●
Prepare edges of the cut-out to remove sharp edges and burrs.
■
Step 3: Installing the AC Drive into the Hole Cut-out
●
Lift the AC drive into the cut-out you have prepared.
Insert the AC drive from the correct side of the mounting surface, depending on
whether you are using a front-mounting or a rear-mounting arrangement.
CAUTION
●
Insert securing screws/bolts in the brackets, and secure the AC drive to the backplate.
Through hole installation of a plastic housing
For the sheet metal housing, use a mechanical lift/device to support
the housing in its mounting location until you have fixed it in place.
2. Mechanical Installation
2
- 29 -