K&R GT600-4T132G User Manual page 190

6. Description of Parameters
■
6
- 188 -
Droop Control
The droop control function aims at balancing the load level of two motors that drive
the same load. This function is required only when both master and slave are in speed
control.
A proper droop rate is gradually obtained during drive running. Therefore, do not set F8-
15 to a very large value. Otherwise, steady speed will decline obviously when load is very
large. You must set this parameter in both master and slave.
Figure 6-57 Relationship between droop rate and output torque
Droop rate
(Hz)
●
Droop speed = rated motor frequency x output torque x droop rate
●
Actual AC drive frequency = frequency reference - droop speed
Suppose that F8-15 is set to 10%, rated motor frequency is 50 Hz, and output torque is
50%. Actual drive frequency = 50 Hz – 50 x 50% x (1.00/10) = 47.5 Hz.
Function Code Parameter Name
A8-00 Point-point communication
This function parameter determines whether to enable point-point communication.
The point-point communication indicates direct communication between two or more
drives via CANlink. The master sends frequency or torque reference to slaves based on
frequency or torque signal it receives.
When connecting multiple AC drives via CANlink card, install a terminal resistor to the
CANlink card of the end drive.
Once this function is enabled, CANlink communication addresses of the master and
slaves are matched automatically. The baud rate is set in Fd-00.
Function Code Parameter Name
A8-01 Master or slave selection
This function parameter determines whether the AC drive is master or slave.
0
100%
Setting Range
0: Disabled
1: Enabled
Setting Range
0: Master
1: Slave
Output
torque (%)
Default
0
Default
0