K&R GT600-4T132G User Manual page 12

1. Product Information
Figure 1-3 Internal view of GT600-4T45GB to GT600-4T160G (sheet metal housing)
1
Front cover
For removal of the front
cover, see section 2.5.
Warning label
- 10 -
Barcode
View the serial number and model of the drive here.
Fixing pin of
extension PG card
See section 8.4.3.
Cabling tray and
fixing pin of ground
cable of control board
This ground cable can only be
connected to the ground bar after the
Logo
system is grounded reliably.
Otherwise, connect it to the fixture.
Ground bar
Ground the PG card and control
board only after ensuring reliable
system grounding.
Wiring description label
Fixing pin of extension card
See sections 8.4.1 and 8.4.2.
EMC and VDR screw
Refer to Power Grid System in
section 3.2.2 and requirement on
current leakage in section 9.1.8.
Protective cover of
main circuit terminals
Main circuit terminals
See section 3.2.1.
Read the user guide of the AC drive carefully before installation or operation.
i
Do not remove the front cover while the power is on or within10
minutes after the power is turned off.
Wait for a period of 10 minutes after the AC drive is powered off
10min
before starting any repair, maintenance or wiring work .
Cable gland hole
Cooling fan
For replacement, see section 10.3.
Operating panel
See section 4.2.
Interface of remote
operating panel
Refer to section 8.3.
Control Circuit
Terminals
See section 3.3.1.
Cable clamp
Fix signal cables
Nameplate
Refer to Figure 1.1.
Grounding
Housing
terminal
See section 3.2.2.