K&R GT600-4T132G User Manual page 13

Figure 1-4 Internal view of GT600-4T200G to GT600-4T450G
Protective cover of
DC bus terminals
DC bus terminals
Barcode
View the serial number and
model of the drive here.
Nameplate
Fixing pin of
extension PG card
See section 8.4.3.
Cabling tray and fixing
pin of ground cable of
control board
This ground cable can only be
connected to the ground bar after
the system is grounded reliably.
Ground bar
It is used for grounding of the
PG card and control board.
Fixing pin of
extension card
See sections 8.4.1 and 8.4.2.
Housing
Live indicator
Do not remove/install the drive
when this indicator is lighting.
EMC and VDR screw
Refer to Power Grid System in
section 3.2.2 and requirement on
current leakage in section 9.1.8.
Input terminals (R, S, T)
See sections 3.2.1.
Bottom hoist hole
Top hoist rings
Operating panel
See section 4.2.
Interface of remote
operating panel
See section 8.3.
Logo
Control circuit
terminals
See sections 3.3.
Cable clamp
Label of main
circuit wiring
Handle
Front cover
See section 2.5.
Fan box
For replacement of fan,
see section 10.3.
Output terminals Warning
(U, V, W) label
Grounding terminal
See sections 3.2.2.
Castor
Read the user guide of the AC drive carefully before
i
installation or operation.
Do not remove the front cover while the power is on or
within10 minutes after the power is turned off.
Wait for a period of 10 minutes after the AC drive is powered
10min
off before starting any repair, maintenance or wiring work .
1. Product Information
- 11 -
1