K&R GT600-4T132G User Manual page 289

9. Maintenance and Inspection
■
Removing and Installing the Fan of GT600-4T200G(-L) to GT600-4T450G(-L)
10
■
Replacement of Electrolytic Capacitor
If replacement of electrolytic capacitor is required, contact the agent or K&R to perform
complete drive replacement.
- 286 -
Removal
1. Disconnect the six screws and remove the front cover.
2. Disconnect the fan power cable connector from the drive. Each fan has a power cable
connector.
3. Remove three screws from the fan box and draw the fan box out in the direction of arrow.
4. Loosen four screws from each fan cover and remove the fan.
1
Installing
1. Put the three fans into the fan box one by one and secure them by fixing the screws.
2. Align the fan box to the rail and push it into the drive.
3. Connect the fan power cable connectors and fix the three screws.
4. After replacement is completed, check that the air flow direction is upright.
2
3
4
10