K&R GT600-4T132G User Manual page 30

2
■
- 28 -
●
The AC drive enclosed in a sheet-metal housing have weights of
CAUTION
35 kg or more. These units have eye bolts that allow a mechanical
hoist to support the weight of the unit during installation. To prevent
personal injury or damage to the equipment, you must fit and use
these eye bolts to support the drive during installation.
●
Always use suitable help to carry, move or support heavy drive
housings. The sheet-metal housings are heavy, and you risk personal
injury or damage to equipment if you attempt to carry, move or
support them without help.
●
Lay the drive housing on a strong, flat surface with control panel facing upwards.
●
Fit the supplied through-hole mounting brackets to the housing:
Fit brackets in correct orientation, depending on whether you are pushing the housing
through the front or from the rear of the supporting surface.
For sheet metal housing, use the two supplied eye bolts to secure the bracket to the
top of the housing.
Through-hole mounting bracket installation for a plastic housing
Through-hole
mounting bracket
Through-hole mounting bracket installation for a sheet metal housing
Through-hole
mounting bracket
●
Ensure all screws and bolts that secure the brackets to the housing are tight.
The through-hole mounting bracket is an option. For dimensions, refer to the
Note
chart in
Step 2: Preparing the Backplate for Hole Cut-out
●
Refer to to identify your model of the drive housing, and make a careful note
of the following dimensions:
●
Mounting hole distances A and B
2. Mechanical Installation
Through-hole
mounting bracket
.