K&R GT600-4T132G User Manual page 223

Terminal Corresponding Function Code
FM-CME F5-06 when F5-00 = 0
F5-01 when F5-00 = 1
TA-TB-TC F5-02
PA-PB-PC F5-03
DO1-CME F5-04
DO2-CME F5-05
When F5-00 = 0, FM terminal is high-speed pulse output. Frequency of pulses on this DO
terminal indicates the value of internal running parameters. Higher values of internal running
parameters produce higher pulse frequencies. Value 100% corresponds to a pulse frequency of
100 kHz.
■
Use of AI Terminals
The drive supports a maximum of three analog input terminals. Of these, AI1 and AI2 are on the
control board, and AI3 is on the optional extension card.
Terminal
AI1-GND
AI2-GND
AI3-GND
Analog inputs allow an external voltage or current signal to set frequency reference, torque
reference, voltage setting at V/F separation, and PID reference and feedback. F4-13 to F4-27
define relationship between analog input voltage or current signals and actual controlled setting
or feedback.
Sampling of analog values on AI terminals is possible by reading function codes:
● U0-09 shows value of AI1.
● U0-10 shows value of AI2.
● U0-11 shows value of AI3.
■
Use of AO Terminals
The drive supports a maximum of two analog output terminals. AO1 is on the control board and
AO2 is on the optional extension card.
Output Feature Description
Transistor
Able to output high-speed pulses 10 Hz to 100 KHz
Drive capacity: 24 VDC, 50 mA
Transistor
Drive capacity: 24 VDC, 50 mA
Relay
Drive capacity: 50 VAC, 0.2 A/30 VDC, 1 A
Extension card, relay; drive capacity: 50 VAC, 0.2
A/30 VDC, 1 A
Transistor
Drive capacity: 24 VDC, 50 mA
Extension card transistor
Drive capacity: 24 VDC, 50 mA
Input Signal Characteristic
It receives the signal of 0 to 10 VDC.
If J9 jumps to the "V" position, AI receives voltage signal of 0 to 10 VDC.
If J9 jumps to the "I" position, AI receives current signal of 0 to 20 mA.
It receives signal of -10 to 10 VDC.
7. Interfaces and Communication
7
- 221 -