K&R GT600-4T132G User Manual page 41

●
Ensure the four mounting holes on the back of the drive are connected to
Note
the beams securely.
●
After push-in is completed, remove the baffle on the top of the drive. The
baffle is used to prevent foreign objects such as screws from falling into the
ventilation when mounting the drive in the cabinet.
●
Please use top hoist rings to move or hoist the drive. If it is necessary to
place the drive in a horizontal position, use the top hoist ring and bottom
hoist hole when you hoist the drive again. Ensure the DC bus terminals
suffer no stress.
●
If it is necessary to place the drive in an upright position, prevent a stress
on both sides of the drive and prevent placing the drive on an inclined floor
because the drive weighs almost 200 kg. If inclination exceeds 5° , the drive
may turn over.
2. Mechanical Installation
Baffle of ventilation
2
- 39 -