K&R GT600-4T132G User Manual page 69

●
Source wiring
Figure 3-23 Wiring in SOURCE mode
+VCC
PNP
Signal
0V
External
controller
Internal 24 V power supply is applied.
If you intend to use internal power supply of the drive, remove the jumper between
terminals +24V and OP. Connect +24V to the common port of external controller, and
connect terminal OP to terminal COM.
If you intend to use an external power supply, remove the jumper between terminals
+24V and OP. Connect external power 0V to terminal OP, and the positive side of
external power +24V to corresponding DI terminal via contact on external controller.
■
Wiring of DI5 (High-speed Pulse Input)
As high speed pulse input terminal, DI5 allows maximum frequency input of 100 kHz.
Figure 3-24 Wiring of high-speed pulse input terminal
Pulse output device
+24V
OP
DI1
DI5
COM
GT600 drive
control board
+24V
OP
DI5
COM
3. Electrical Installation
+24V
OP
DI1
PNP
Signal
DI5
0V
External GT600 drive
controller control board
External 24 V power supply is applied.
GT600
3
- 67 -