Parameter Settings - Mitsubishi QJ71LP21 Reference Manual

5 PARAMETER SETTINGS

5 PARAMETER SETTINGS
There is a needed use GX Developer to set the remote master station CPU module
and each of the parameters in the remote I/O station network module in order to make
the remote I/O network operate.
In setting the parameters, it is possible to make settings from the selection of the type
of MELSECNET/H to the application functions.
The following is a flow chart of the settings.
(1) Parameter settings for the remote master station
Not required
5 - 1
Setting the number of module cards
Network type · · · · MNET/H (Remote master)
Network settings
(1) Starting I/O No.
(2) Network No. · · · · 1 to 239
(3) Total stations · · · ·
Remote master station only
Common parameters
(1) Transmission range of each station
(LB/LW, LX/LY setting)
Set the following items as necessary.
(2) Reserved station setting
Auxiliary setting
Set the following functions
as necessary.
Refresh parameter settings
Setting of valid module during other station access
Routing parameter settings
Interrupt setting parameter settings
Redundant settings for redundant system
Writing parameter to CPU module
CPU module reset
To cable connection
1: Refer to the Q-corresponding MELSECNET/H network system reference
manual (PLC to PLC network) for details.
2: Make the settings only when using the redundant system.
3: For the redundant system, write the parameter to the CPU module of the
control system.
· · · ·
· · · ·
· · · ·
· · · ·
Required
· · · ·
1
· · · ·
· · · ·
2
3
· · · ·
MELSEC-Q
Section 5.1.1
Section 5.1.2
Section 5.1.3
Section 5.1.4
Section 5.1.5
Section 7.7
Section 5.1.7
Section 4.6
5 - 1
5