Table of Contents
Advertisement
Configuration and management
5. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set a new password for the admin user. The password must be at least eight characters long
and must contain at least one uppercase letter, one lowercase letter, one number, and one
special character.
(config)> auth user admin password new-password
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configuration methods
There are two primary methods for configuring your Connect EZ device:
Web interface.
n
The web interface can be accessed in two ways:
Central management using the Digi Remote Manager, a cloud-based device management
l
and data enablement platform that allows you to connect any device to any application,
anywhere. With the Remote Manager, you can configure your Connect EZ device and use
the configuration as a basis for a profile which can be applied to other similar devices. See
Using Digi Remote Manager
manage and configure your Connect EZ device.
The local web interface. See
l
local web interface to manage and configure your Connect EZ device.
Digi Connect EZ Mini User Guide
for more information about using the Remote Manager to
Using the web interface
for more information about using the
Configuration methods
39
Advertisement
Table of Contents
