Table of Contents
Advertisement
System administration
1. Log into the Connect EZ WebUI as a user with Admin access.
2. On the menu, click System. Under Administration, click Find Me.
A notification message appears, noting that the LED is flashing on the device. Click the x in the
message to close it.
3. On the menu, click System again. Ablue circle next to Find Me is blinking, indicating that the
Find Me feature is active.
4. To deactivate the Find Me feature, click System and click Find Me again.
A notification message appears, noting that the LED is no longer flashing on the device. Click
the x in the message to close it.
Command line
1. Log into the Connect EZ command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To activate the Find Me feature, at the prompt, type the following at the command prompt:
> system find-me on
>
3. To deactivate the Find Me feature, type the following at the command prompt:
> system find-me off
>
4. To determine the status of the Find Me feature, type the following at the command prompt:
> system find-me status
off
>
Digi Connect EZ Mini User Guide
Locate the device by using the Find Me feature
519
Advertisement
Table of Contents
