Table of Contents
Advertisement
User authentication
(config)> add auth method end ldap
(config)>
14. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
15. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure serial authentication
This section describes how to configure authentication for serial access.
WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Authentication > Serial.
4. (Optional) For TLS identity certificate, paste a TLS certificate and private key in PEM format.
If empty, the certificate for the web administration service is used. See
administration service
5. For Peer authentication, select the method used to verify the certificate of a remote peer.
6. Include standard CAs is enabled by default. This allows peers with certificates that have been
signed by standard Certificate Authorities (CAs) to authenticate.
7. Click to expand Custom certificate authorities to add the public certificates of custom CAs.
a. For Add CA certificate, type the name of a custom CA and click .
b. Paste the public certificate for the custom CA in PEM format.
c. Repeat for additional custom CA certificates.
8. Click to expand Peer certificates to add the public certificates of trusted peers.
a. For Add Peer certificate, type the name of a trusted peer and click .
b. Paste the public certificate for the trusted peer in PEM format.
c. Repeat for additional trusted peer certificates.
Digi Connect EZ Mini User Guide
for more information.
Configure serial authentication
Configure the web
457
Advertisement
Table of Contents
