Digi Connect EZ Mini User Manual page 90

Firmware version 22.2

Hide thumbs Also See for Connect EZ Mini:

Table of Contents

2. At the command line, type config to enter configuration mode:

3. The serial port is enabled by default. To disable:

(config)> serial port1 enable false

4. Set the mode:

(config)> serial port1 mode remoteaccess

5. Enable Altpin to use the Altpin feature. Altpin is disabled by default.

(config)> serial port1 altpin true

This feature should be enabled when you are using a modem and an 8-pin cable and you need

CD (Carrier Detect). When enabled, the DTR on pin 1 drives DCD.

If altpin is disabled, the hardware signal on RJ45 pin 1 becomes DSR instead of DCD. This

alternative can be used if DCD is not required, and DSR is needed instead.

Enable rts_toggle if you want to enable RTS toggling during transmission on this

serial port. If enabled, this setting overrides RTS\CTS flow control:

For rts_pre_delay, enter the amount of time RTS is asserted before starting data

transmission. The time is measured in milliseconds. The default is 0ms:

For rts_post_delay, enter the amount of time RTS is deasserted before completing

data transmission. The time is measured in milliseconds. The default is 0ms:

Enable Termination if you want to enable electrical termination on this serial port.

Enable termination if you want to enable electrical termination on this serial port:

Digi Connect EZ Mini User Guide

(config)> serial port1 rts_toggle true

(config)> serial port1 "rts_pre_delay value

(config)> serial port1 rts_post_delay value

(config)> serial port1 termination true

Configure Remote Access mode