Digi Connect EZ Mini User Manual page 99

Serial port
9. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. The serial port is enabled by default. To disable:
(config)> serial port1 enable false
(config)>
4. Set the signal mode:
(config)> serial port1 signal mode value
(config)>
where value is one of:
rs-232
n
Enable rts_toggle if you want to enable RTS toggling during transmission on this
l
serial port. If enabled, this setting overrides RTS\CTS flow control:
For rts_pre_delay, enter the amount of time RTS is asserted before starting data
l
transmission. The time is measured in milliseconds. The default is 0ms:
For rts_post_delay, enter the amount of time RTS is deasserted before completing
l
data transmission. The time is measured in milliseconds. The default is 0ms:
Digi Connect EZ Mini User Guide
(config)> serial port1 rts_toggle true
(config)>
(config)> serial port1 "rts_pre_delay value
(config)>
Configure RealPort mode
99