Table of Contents
Advertisement
Serial port
(config)>path-paramhistory bytes
(config)
The default is 4000 bytes.
d. Set the amount of time to wait before disconnecting due to user inactivity:
(config)>path-paramidle_timeout value
(config)
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set idle_timeout to ten minutes, enter either 10m or 600s:
(config)>path-paramidle_timeout 600s
(config)
The default is 15m.
13. Configure monitor settings.
a. (Optional) Enable monitoring of CTS (Clear to Send) changes on this port:
(config)>path-parammonitor cts true
(config)
b. (Optional) Enable monitoring of DCD (Data Carrier Detect) changes on this port:
(config)>path-parammonitor dcd true
(config)
14. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
15. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure Application mode
Application mode provides access to the serial device from Python applications.
To change the configuration to match the serial configuration of the device to which you want to
connect:
WebUI
Digi Connect EZ Mini User Guide
Configure Application mode
92
Advertisement
Table of Contents
