Delete A Wan - Digi Connect EZ Mini User Manual

Firmware version 22.2

Hide thumbs Also See for Connect EZ Mini:

Table of Contents

Delete a WAN

Follow this procedure to delete any WANs that have been added to the system. You cannot delete the

preconfigured WAN, ETH1.

1. Log into the Connect EZ WebUI as a user with full Admin access rights.

2. On the menu, click System. Under Configuration, click Device Configuration.

The Configuration window is displayed.

3. Click Network > Interfaces.

4. Click the menu icon (...) next to the name of the WAN to be deleted and select Delete.

5. Click Apply to save the configuration and apply the change.

Command line

1. Log into the Connect EZ command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. Use the del command to delete the WAN. For example, to delete a WAN named my_wan:

(config)> del network interface my_wan

4. Save the configuration and apply the change:

(config)> save

Configuration saved.

5. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Digi Connect EZ Mini User Guide

Wide Area Networks (WANs)