Table of Contents
Advertisement
Interfaces
For example, to set Initial connection time to ten minutes, enter 10m or 600s.
The default is 60 seconds.
13. Optional active recovery configuration parameters:
a. For Restart interface, enable to configure the device to restart the interface when its
connection is considered to have failed. This is useful for interfaces that may regain
connectivity after restarting.
b. For Reboot device, enable to instruct the device to reboot when the WAN connection is
considered to have failed.
c.
Note
If both the Restart interface and Reboot device parameters are enabled, the
Reboot device parameter takes precedence.
d. Change the Interval between connectivity tests.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Interval to ten minutes, enter 10m or 600s.
The default is 15 minutes.
e. If more than one test target is configured, for Success condition, determine whether the
interface should fail over based on the failure of one of the test targets, or all of the test
targets.
f. For Attempts, type the number of probe attempts before the WAN is considered to have
failed.
g. For Response timeout, type the amount of time that the device should wait for a response
to a probe attempt before considering it to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Response timeout to ten minutes, enter 10m or 600s.
The default is 15 seconds.
14. (Optional) Repeat this procedure for IPv6.
15. Click Apply to save the configuration and apply the change.
Command line
Active recovery can be configured for both IPv4 and IPv6. These instructions are for IPv4; to configure
IPv6 active recovery, replace ipv4 in the command line with ipv6.
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
Digi Connect EZ Mini User Guide
Wide Area Networks (WANs)
61
Advertisement
Table of Contents
