Table of Contents
Advertisement
Services
2. Use the
show ntp
> show ntp
NTP Status Status
-----------------
Status
Sync Status : Up
Remote
Offset
----------------
-
------
*ec2-52-2-40-158
+1.561
128.136.167.120
1.895
0.382
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure a multicast route
Multicast routing allows a device to transmit data to a single multicast address, which is then
distributed to a group of devices that are configured to be members of that group.
To configure a multicast route:
WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Multicast.
4. For Add Multicast route, type a name for the route and click .
5. The new route is enabled by default. To disable, uncheck Enable.
6. Type the Source address for the route. This must be a multicast IP address between 224.0.0.1
and 239.255.255.255.
7. Select a Source interface where multicast packets will arrive.
8. To add one or more destination interface that the Connect EZ device will send mutlicast
packets to:
Digi Connect EZ Mini User Guide
command at the system prompt:
: Up
Refid
Jitter
-------------
129.6.15.32
0.991
128.227.205.3
Configure a multicast route
ST
T
When
Poll
Reach
--
-
----
----
-----
2
u
191
1024
377
3
u
153
1024
1
Delay
------
-----
33.570
43.583
-
341
Advertisement
Table of Contents
