Table of Contents
Advertisement
User authentication
(config)> add auth method end local
(config)>
5. Create the user. In this example, the user is being created with the username adminuser:
(config)> add auth user adminuser
(config auth user adminuser)>
6. Assign a password to the user:
(config auth user adminuser)> password pwd
(config auth user adminuser)>
7. Assign the user to the admin group:
(config auth user adminuser)> add group end admin
(config auth user adminuser)>
8. Save the configuration and apply the change:
(config auth user adminuser)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Example 2: RADIUS, TACACS+, and local authentication for one user
Goal: To create a user with administrator rights who is authenticated by using all three authentication
methods.
In this example, when the user attempts to log in to the Connect EZ device, user authentication will
occur in the following order:
1. The user is authenticated by the RADIUS server. If the RADIUS server is unavailable,
2. The user is authenticated by the TACACS+ server. If both the RADIUS and TACACS+ servers are
unavailable,
3. The user is authenticated by the Connect EZ device using local authentication.
This example uses a FreeRadius 3.0 server running on ubuntu, and a TACACS+ server running on
ubuntu. Server configuration may vary depending on the platforms or type of servers used in your
environment.
Digi Connect EZ Mini User Guide
Example user configuration
464
Advertisement
Table of Contents
