Table of Contents
Advertisement
Virtual Private Networks (VPN)
n
14. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new PPP-over-L2TP access concatenator , or edit an existing one:
To create a new PPP-over-L2TP access concatenator , see
n
tunnel.
To edit an existing PPP-over-L2TP access concatenator , change to the PPP-over-L2TP
n
access concatenator node in the configuration schema. For example, for an PPP-over-
L2TP access concatenator named lac_tunnel, change to the lac_tunnel node in the
configuration schema:
(config)> vpn l2tp lac lac_tunnel
(config vpn l2tp lac lac_tunnel)>
4. Enable active recovery:
(config vpn l2tp lac lac_tunnel)> surelink enable true
(config vpn l2tp lac lac_tunnel)>
5. To configure the device to restart the interface when its connection is considered to have
failed:
Digi Connect EZ Mini User Guide
Test the interface status: The interface is considered to be down based on:
Down time: The amount of time that the interface can be down before this test
l
is considered to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and
take the format number{w|d|h|m|s}.
For example, to set Down time to ten minutes, enter 10m or 600s.
The default is 60 seconds.
Initial connection time: The amount of time to wait for an initial connection to
l
the interface before this test is considered to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and
take the format number{w|d|h|m|s}.
For example, to set Initial connection time to ten minutes, enter 10m or 600s.
The default is 60 seconds.
L2TP
Configure a PPP-over-L2TP
235
Advertisement
Table of Contents
