Digi Connect EZ Mini User Manual page 152

Virtual Private Networks (VPN)
1. Configure the primary IPsec tunnel. See
During configuration of the IPsec tunnel, set the metric to a low value (for example, 10):
n
(config vpn ipsec tunnel IPsecFailoverPrimaryTunnel)> metric 10
(config vpn ipsec tunnel IPsecFailoverPrimaryTunnel)>
Configure SureLink for the primary IPsec tunnel and enable Restart interface. See
n
Configure SureLink active recovery for IPsec
(config vpn ipsec tunnel IPsecFailoverPrimaryTunnel)> surelink
restart true
(config vpn ipsec tunnel IPsecFailoverPrimaryTunnel)>
2. Create a backup IPsec tunnel. Configure this tunnel to use the same local and remote
endpoints as the primary tunnel. See
During configuration of the IPsec tunnel, set the metric to a value that is higher than the
n
metric of the primary tunnel (for example, 20):
(config vpn ipsec tunnel IPsecFailoverBackupTunnel)> metric 20
(config vpn ipsec tunnel IPsecFailoverBackupTunnel)>
IPsec failover using Preferred tunnel

WebUI
1. Configure the primary IPsec tunnel. See
2. Create a backup IPsec tunnel. See
3. During configuration of the backup IPsec tunnel, identify the primary IPsec tunnel in the
Preferred tunnel parameter:

Command line
1. Configure the primary IPsec tunnel. See
2. Create a backup IPsec tunnel. See
3. During configuration of the backup IPsec tunnel, identify the primary IPsec tunnel:
a. Use the ? to view a list of available tunnels:
(config vpn ipsec tunnel backup_ipsec_tunnel)> ipsec_failover ?
Preferred tunnel: This tunnel will not start until the preferred
tunnel has failed. It will continue
to operate until the preferred tunnel returns to full operation
Digi Connect EZ Mini User Guide
Configure an IPsec tunnel
for instructions.
Configure an IPsec tunnel
Configure an IPsec tunnel
Configure an IPsec tunnel
Configure an IPsec tunnel
Configure an IPsec tunnel
for instructions.
for instructions.
for instructions.
for instructions.
for instructions.
for instructions.
IPsec
152