Table of Contents
Advertisement
Diagnostics
1. Log into the Connect EZ command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the
show event
> show event
Timestamp
---------------- ------- --------- --------------------------------------
-----
Nov 26 21:42:37
intf=eth1~type=ethernet~rx=11332435~tx=5038762
Nov 26 21:42:35
+0000~uptime=3 hours, 0 minutes, 48 seconds
...
>
3. (Optional) Use the show event number num command to limit the number of lines that are
displayed. For example, to limit the event list to the most recent ten lines:
> show event number 10
Timestamp
---------------- ------- --------- --------------------------------------
-----
Nov 26 21:42:37
intf=eth1~type=ethernet~rx=11332435~tx=5038762
Nov 26 21:42:35
+0000~uptime=3 hours, 0 minutes, 48 seconds
...
>
4. (Optional) Use the show event table value command to limit the number of lines that are
displayed. Allowed values are error, info, and status. For example, to limit the event list to
only info messages:
> show event table info
Timestamp
---------------- ------- --------- --------------------------------------
-----
Nov 26 22:01:26
name=admin~service=cli~state=opened~remote=192.168.1.2
Nov 26 22:01:25
name=admin~service=cli~state=closed~remote=192.168.1.2
...
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Digi Connect EZ Mini User Guide
command at the Admin CLI prompt:
Type
Category
Message
status
stat
status
system
local_time=Thu, 08 Aug 2019 21:42:35
Type
Category
Message
status
stat
status
system
local_time=Thu, 08 Aug 2019 21:42:35
Type
Category
Message
info
user
info
user
View system and event logs
580
Advertisement
Table of Contents
