Table of Contents
Advertisement
System administration
Note
If your device is managed by a Digi Remote Manager configuration, the configuration
manages the device's firmware version. You should not enable this option.
5. (Optional) Configure automated checking for device and modem firmware updates:
a. Device firmware update check is enabled by default. This enables to automated
checking for device firmware updates. To disable:
(config)> system schedule maintenance firmware_update_check device
false
(config)>
b. Modem firmware update check is enabled by default. This enables to automated
checking for modem firmware updates.
(config)> system schedule maintenance firmware_update_check modem
false
(config)>
c. Set how often automated checking for device and modem firmware should take place:
(config)> system schedule maintenance frequency value
(config)>
where value is either daily, weekly, or monthly. daily is the default.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Disable device encryption
You can disable the cryptography on your Connect EZ device. This can be used to ship unused devices
from overseas without needing export licenses from the country from which the device is being
shipped.
When device encryption is disabled, the following occurs:
The device is reset to the default configuration and rebooted.
n
After the reboot:
n
Access to the device via the WebUI and SSH are disabled.
l
All internet connectivity is disabled, including WAN. Connectivity to central management
l
software is also disabled.
All IP networks and addresses are disabled except for the default 192.168.210.1/24 network
l
on the local LAN Ethernet port. DHCP server is also disabled.
Digi Connect EZ Mini User Guide
Disable device encryption
529
Advertisement
Table of Contents
