Table of Contents
Advertisement
Serial port
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. The serial port is enabled by default. To disable:
(config)> serial port1 enable false
(config)>
4. Set the mode:
(config)> serial port1 mode login
(config)>
5. Enable Altpin to use the Altpin feature. Altpin is disabled by default.
(config)> serial port1 altpin true
(config)>
This feature should be enabled when you are using a modem and an 8-pin cable and you need
CD (Carrier Detect). When enabled, the DTR on pin 1 drives DCD.
If altpin is disabled, the hardware signal on RJ45 pin 1 becomes DSR instead of DCD. This
alternative can be used if DCD is not required, and DSR is needed instead.
6.
rs-232
n
Enable rts_toggle if you want to enable RTS toggling during transmission on this
l
serial port. If enabled, this setting overrides RTS\CTS flow control:
For rts_pre_delay, enter the amount of time RTS is asserted before starting data
l
transmission. The time is measured in milliseconds. The default is 0ms:
For rts_post_delay, enter the amount of time RTS is deasserted before completing
l
data transmission. The time is measured in milliseconds. The default is 0ms:
rs-422
n
Enable Termination if you want to enable electrical termination on this serial port.
l
Digi Connect EZ Mini User Guide
(config)> serial port1 rts_toggle true
(config)>
(config)> serial port1 "rts_pre_delay value
(config)>
(config)> serial port1 rts_post_delay value
(config)>
Configure Login mode
85
Advertisement
Table of Contents
