Manage Elements In Lists - Digi Connect EZ Mini User Manual

Command line interface
1. At the config prompt, type service to move to the service node:
(config)> service
(config service)>
2. Type ssh to move to the ssh node:
(config service)> ssh
(config service ssh)>
3. Type acl to move to the acl node:
(config service ssh)> acl
(config service ssh acl)>
4. Type zone to move to the zone node:
(config service ssh acl)> zone
(config service ssh acl zone)>
You can also enter multiple nodes at once to move multiple steps in the configuration:
(config)> service ssh acl zone
(config service ssh acl zone)>
Move backward one node in the configuration by entering two periods (..):
n
(config service ssh acl zone)> ..
(config service ssh acl)>
You can also move back multiples nodes in the configuration by typing multiple sets of two
periods:
(config service ssh acl zone)> .. .. ..
(config service)>
Move to the root of the config prompt from anywhere within the configuration by entering
n
three periods (...):
(config service ssh acl zone)> ...
(config)>

Manage elements in lists

While in configuration mode, you can use the add, del, and move action commands to manage
elements in a list. When working with lists, these actions require an index number to identify the list
item that will be acted on.
Add elements to a list
When used with parameters that contains lists of elements, the add command is used to add an
element to the list.
For example, to add an authentication method:
Digi Connect EZ Mini User Guide
Configuration mode
628