Table of Contents
Advertisement
Central management
3. Click Central management.
The Central management configuration window is displayed.
Digi Remote Manager support is enabled by default. To disable, click Enable central
management.
4. (Optional) For Service, select either Digi Remote Manager or Digi aView. The default is Digi
Remote Manager.
5. (Optional) For Management server, type the URL for the central management server.
The default varies depending on firmware versions:
Firmware version 22.2.9.x and newer, the default is the edp12.devicecloud.com. This
n
server is for device-connectivity only, and uses enhanced security through certificate-
based communication. See
Firmware prior to version 22.2.9.x, the default is the Digi Remote Manager server,
n
my.devicecloud.com.
6. (Optional) For Management port, type the destination port for the remote cloud services
connection. The default is 3199.
7. (Optional) For Retry interval, type the amount of time that the Connect EZ device should wait
before reattempting to connect to remote cloud services after being disconnected. The default
is 30 seconds.
Allowed values are any number of hours, minutes, or seconds, and take the format number
{h|m|s}.
For example, to set Retry interval to ten minutes, enter 10m or 600s.
8. (Optional) For Keep-alive interval, type the amount of time that the Connect EZ device should
wait between sending keep-alive messages to remote cloud services when using a non-cellular
interface. The default is 60 seconds.
Allowed values are any number of hours, minutes, or seconds, and take the format number
{h|m|s}.
For example, to set Keep-alive interval to ten minutes, enter 10m or 600s.
Note
The Cellular keep-alive interval is not used by the Connect EZ. Any entry is ignored.
9. (Optional) For Allowed keep-alive misses, type the number of allowed keep-alive misses. The
default is 3.
Digi Connect EZ Mini User Guide
Digi Remote Manager support
Configure Digi Remote Manager
for further infomation.
551
Advertisement
Table of Contents
