Table of Contents
Advertisement
Diagnostics
d. Select the event categories that will be sent to the server. By default, all event categories
are enabled. You can disable logging for error, informational, and status event categories
by clicking to toggle off the category.
e. For Syslog egress port, type the port number to use for the syslog server. The default is
514.
f. For Protocol, select the IP protocol to use for communication with the syslog server.
Available options are TCP and UPD. The default is UPD.
5. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. (Optional) To configure remote syslog servers:
a. Add a remote server:
(config)> add system log remote end
(config system log remote 0)>
b. Enable the server:
(config system log remote 0)> enable true
(config system log remote 0)>
c. Set the host name or IP address of the server:
(config system log remote 0)> server hostname
(config system log remote 0)>
d. The event categories that will be sent to the server are automatically enabled when the
server is enabled.
n
Digi Connect EZ Mini User Guide
To disable informational event messages:
(config system log remote 0)> info false
(config system log remote 0)>
Configure syslog servers
582
Advertisement
Table of Contents
