Table of Contents
Advertisement
Virtual Private Networks (VPN)
Enable
Status
Hostname
Zone
Mode
Type
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Debug an IPsec configuration
If you experience issues with an IPsec tunnel not being successfully negotiated with the remote end of
the tunnel, you can enable IPsec debug messages to be written to the system log. See
and event logs
for more information about viewing the system log.
WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click VPN > IPsec.
4. Click to expand Advanced.
5. For Debug level, select one of the following:
Disable debug messages.
n
Basic auditing debug: Logs basic auditing information, (for example, SA up/SA down).
n
Generic control flow : Select this for basic debugging information.
n
Detailed control flow : More detailed debugging control flow.
n
Raw data: Includes raw data dumps in hexadecimal format.
n
Sensitive material: Also includes sensitive material in dumps (for example, encryption
n
keys).
6. Click Apply to save the configuration and apply the change.
Command line
Digi Connect EZ Mini User Guide
: true
: pending
: 192.168.2.1
: ipsec
: tunnel
: esp
IPsec
View system
161
Advertisement
Table of Contents
