Table of Contents
Advertisement
Hardware
Note
Screws are not provided.
Mounting onto soft or thin materials
Examples: Wallboard, sheetrock, wood, thin sheet metal, or plastic.
Use a screw that meets these requirements:
M4 pan-head Philips screw
n
Coarse-thread sheet metal screw
n
12 mm in length. The length should clear the mounting tab thickness and leave at least 1 cm of
n
screw shank to bite into the mounting material.
Mounting onto thicker metals
Examples: Aluminum or steel.
Use a screw that meets these requirements:
M4 pan-head Philips screw
n
Machine-thread screw
n
12 mm in length. The length should clear the mounting tab thickness and leave at least 1 cm of
n
screw shank to bite into the mounting material.
Attach to DIN rail with clip
The DIN rail clip and two screws are included with the device. You will need an appropriate Phillips-
head screwdriver. For details about the hardware, see
1. Remove required items from DIN rail mounting kit:
DIN rail clip
n
Two flat head screws.
n
2. Place the DIN rail clip on the rear panel of the device. Make sure the screw holes are aligned.
3. In each hole, use a Phillips-head screw driver to screw in a screw.
4. Tighten the screws as needed to securely fasten the DIN rail clip to the device.
5. Set the device onto a DIN rail and gently press until the clip snaps into the rail.
Digi Connect EZ Mini User Guide
Mount the Connect EZ device
DIN rail clip
information.
30
Advertisement
Table of Contents
