Table of Contents
Advertisement
Services
b. Set the IP address of the DNS server:
(config service dns server 0)> address ip-addr
(config service dns server 0)>
c. To restrict the device's use of this DNS server based on the domain, use the domain
command. If no domain are listed, then all queries may be sent to this server.
(config service dns server 0)> domain domain
(config service dns server 0)>
d. (Optional) Set a label for this DNS server:
(config service dns server 0)> label label
(config service dns server 0)>
9. (Optional) Add host names and their IP addresses that the device's DNS server will resolve
a. Add a host:
(config)> add service dns host end
(config service dns host 0)>
b. Set the IP address of the host:
(config service dns host 0)> address ip-addr
(config service dns host 0)>
c. Set the host name:
(config service dns host 0)> name host-name
(config service dns host 0)>
10. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show DNS server
You can display status for DNS servers. This command is available only at the Admin CLI.
Command line
Digi Connect EZ Mini User Guide
Configure DNS
278
Advertisement
Table of Contents
