Table of Contents
Advertisement
Interfaces
c. Click IPv6.
d. For Metric, type 1.
4. Set the metrics for ETH1:
a. Click Network > Interfaces > ETH1 > IPv4.
b. For Metric, type 2.
c. Click IPv6.
d. For Metric, type 2.
5. Click Apply to save the configuration and apply the change.
The Connect EZ device is now configured to use the cellular modem WWAN, Modem, as its highest
priority WAN, and its Ethernet WAN, ETH1, as its secondary WAN.
Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the metrics for Modem:
a. Set the IPv4 metric for Modem to 1. For example:
(config)> network interface modem ipv4 metric 1
(config)>
b. Set the IPv6 metric for Modem to 1:
Digi Connect EZ Mini User Guide
Wide Area Networks (WANs)
51
Advertisement
Table of Contents
