Digi Connect EZ Mini User Manual page 246

Virtual Private Networks (VPN)
1. Log into the Connect EZ command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To display details about all configured L2TPv3 Ethernet tunnels, type the following at the
prompt:
> show l2tpeth
Tunnel Session
-----------------
test/session/test
>
3. To display details about a specific tunnel:
> show l2tpeth name /vpn/l2tpeth/test/session/test
test/session/test Tunnel Session Status
---------------------------------------
Enabled
Status
Local IP
Remote IP
Tunnel ID
Peer Tunnel ID
Session ID
Peer Session ID
Lifetime (Actual)
Device
RX Packets
RX Bytes
TX Packets
TX Byptes
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Digi Connect EZ Mini User Guide
Enabled Device
------- ------------
true le_test_test
: true
: up
: 4.3.2.1
: 10.10.10.1
: modem
: 10.10.10.1 === 4.3.2.1
: 255
: 1476
: 600
: le_test_test
: 2,102
: 462
: 2,787
: 3,120
L2TPv3 Ethernet
Status
------
up
246