Table of Contents
Advertisement
Services
Direction
Quality
UTC Date and Time : Thurs, 03 March 2022 10:16:23 03
No. of Satellites : 7
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show geofence information
1. Log into the Connect EZ command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the
show location geofence
> show location geofence
Geofence
-------------
test_geofence
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Modbus gateway
The Connect EZ supports the ability to function as a Modbus gateway, to provide serial-to-Ethernet
connectivity to Programmable Logic Controllers (PLCs), Remote Terminal Units (RTUs), and other
industrial devices. MODBUS provides client/server communication between devices connected on
different types of buses and networks, and the Connect EZ gateway allows for communication
between buses and and networks that use the Modbus protocol.
This section contains the following topics:
Configure the Modbus gateway
Show Modbus gateway status and statistics
Digi Connect EZ Mini User Guide
: None
: Standard GNSS (2D/3D)
command at the system prompt:
Status
State
Transitions
------
------
-----------
Up
Inside
0
Modbus gateway
Last Transition
---------------
315
328
314
Advertisement
Table of Contents
