Table of Contents
Advertisement
Serial port
8. Expand Data Framing Settings.
a. Click Enable to enable the data framing feature.
b. For Maximum Frame Count, enter the maximum size of the packet. The default is 1024.
c. For Idle Time, enter the length of time the device should wait before sending the packet.
d. For End Pattern, enter the end pattern. The packet is sent when this pattern is received
from the serial port.
e. Click Strip End Pattern if you want to remove the end pattern from the packet before it is
sent.
9. Expand UDP Serial Settings.
a. For Local port, enter the UDP port. The default is 4001 or serial port 1, 4002 for serial port
2, etc.
b. (Optional) For Socket String ID, enter a string that should be added at the beginning of
each packet.
c. For Destinations, you can configure the remote sites to which you want to send data. If
you do not specify any destinations, the Connect EZ sends new data from the last IP
address and port from which data was received. To add a destination:
i. Click Add Destination. A destination row is added.
ii. (Optional) For Description, enter a description of the destination.
iii. For Hostname, enter the host name or IP address of the remote site to which data
should be sent.
iv. For Port, enter the port number of the remote site to which data should be sent.
Digi Connect EZ Mini User Guide
Configure UDP serial mode
103
Advertisement
Table of Contents
