Table of Contents
Advertisement
Serial port
RS-232
n
Enable RTS Toggle if you want to enable RTS toggling during transmission on this
l
serial port. If enabled, this setting overrides RTS\CTS flow control.
For RTS Pre-delay, enter the amount of time RTS is asserted before starting data
l
transmission. The time is measured in milliseconds. The default is 0ms.
For RTS Post-delay, enter the amount of time RTS is deasserted before completing
l
data transmission. The time is measured in milliseconds. The default is 0ms.
RS-422
n
Enable Termination if you want to enable electrical termination on this serial port.
l
RS-485
n
Enable Termination if you want to enable electrical termination on this serial port.
l
Enable Full Duplex if you want to enable full duplex communication on this serial
l
port.
The default is RS-232.
8. Expand Serial Settings.
The entries in the following fields must match the information for the power controller. Refer
to your power controller manual for the correct entries.
a. Baud rate: For Baud rate, select the baud rate used by the device to which you want to
connect. The default is 9600.
b. Data bits: For Data bits, select the number of data bits used by the device to which you
want to connect. The default is 8.
c. Parity: For Parity, select the type of parity used by the device to which you want to
connect. The default is None.
d. Stop bits: For Stop bits, select the number of stop bits used by the device to which you
want to connect. The default is 1.
e. Flow control: For Flow control, select the type of flow control used by the device to
which you want to connect. The default is None.
9. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.
Command line
Digi Connect EZ Mini User Guide
Configure Login mode
84
Advertisement
Table of Contents
