Digi Connect EZ Mini User Manual page 91

Serial port
Enable full_duplex if you want to enable full duplex communication on this serial
l
port:
The default is rs-232.
7. (Optional) Set a label that will be used when referring to this port.
(config)>path-paramlabel label
(config)>
8. Set the baud rate used by the device to which you want to connect:
(config)>path-parambaudrate rate
(config)>
9. Set the number of data bits used by the device to which you want to connect:
(config)>path-paramdatabits bits
(config)>
10. Set the type of parity used by the device to which you want to connect:
(config)>path-paramparity parity
(config)>
Allowed values are:
even
n
odd
n
none
n
The default is none.
11. Set the stop bits used by the device to which you want to connect:
(config)>path-paramstopbits bits
(config)>
12. Configure the session settings.
a. Set the characters used to start an escape sequence:
(config)>path-paramescape string
(config)
If no characters are defined, the escape sequence is disabled. The default is ~b.
b. Limit access to the serial port to a single active session:
(config)>path-paramexclusive true
(config)
c. Set the number of bytes of output from the serial port that are written to buffer. These
bytes are redisplayed when a user connects to the serial port.
Digi Connect EZ Mini User Guide
(config)> serial port1 full_duplex true
(config)>
Configure Remote Access mode
91