Table of Contents
Advertisement
Diagnostics
5. Click to download the system log.
Command line
1. Log into the Connect EZ command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the
show log
> show log
Timestamp
--------------
----
Nov 26 21:54:34
up now
Nov 26 21:54:35
...
>
3. (Optional) Use the show log number num command to limit the number of lines that are
displayed. For example, to limit the log to the most recent ten lines:
> show log number 10
Timestamp
--------------
----
Nov 26 21:54:34
up now
Nov 26 21:54:35
...
>
4. (Optional) Use the show log filter value command to limit the number of lines that are
displayed. Allowed values are critical, warning, info, and debug. For example, to limit the
event list to only info messages:
> show log filter info
Timestamp
---------------- ------- --------- --------------------------------------
-----
Nov 26 22:01:26
name=admin~service=cli~state=opened~remote=192.168.1.2
Nov 26 22:01:25
name=admin~service=cli~state=closed~remote=192.168.1.2
Digi Connect EZ Mini User Guide
command at the Admin CLI prompt:
Message
---------------------------------------------------------
Connect EZ netifd: Interface 'interface_wan' is setting
Connect EZ firewalld[621]: reloading status
Message
---------------------------------------------------------
Connect EZ netifd: Interface 'interface_wan' is setting
Connect EZ firewalld[621]: reloading status
Type
Category
info
user
info
user
View system and event logs
Message
578
Advertisement
Table of Contents
