Table of Contents
Advertisement
Serial port
Label
--------
Serial 1
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Log serial port messages
To display and configure the serial port log:
Note
You can access this page by clicking the Log button in the
WebUI
1. Log into the Connect EZ WebUI as a user with Admin access.
2. On the main menu, click Status
3. Under Connections, click Serial.
4. Click Log.
The Serial port log window displays.
5. Click Start to start serial port logging.
6. Click Stop to stop serial port logging if it has been started.
7. Click Refresh to refresh the log display.
8. Click Download to download the serial port log.
9. (Optional) For Log size, configure the maximum allowed log size for the serial port log. The
default is 65536.
Digi Navigator application
You can use the Digi Navigator application with the Connect EZ device to discover device
IP addresses, install and configure RealPort, and verify connection to the network.
Before you begin
Your device must be
after it has been installed.
Use the Digi Navigator application features
These features can be performed from the Digi Navigator.
Configure RealPort
n
Discover the device's IP address
n
Digi Connect EZ Mini User Guide
Port
Enable
Mode
-----
------
-----
port1
true
login
connected to your network or a laptop
Baudrate
--------
9600
Serial Status
before you can access the Digi Navigator
Log serial port messages
page.
113
Advertisement
Table of Contents
